How To Install
Fasteners Needed
¼" x 1 ¼" Hex head Tapcons
¼" x 1 ¾" Hex head Tapcons
Plug End: Male 3 prong
CRC brand spray silicone
Tools Needed
Cordless drill
Hammer drill
¼"Drill bit
3/8" Drill bit
3/16" Masonry drill bit
¼" Nut driver
5/16" Nut driver
Needle nose pliers
Level
Chop saw or hack saw
Installation Instructions
-
Remove 5 screws from housing cover and remove housing cover
-
Pull pin & remove screen roller
-
Predrill ¼" hole in housing
-
For underneath housing mount, drill holes in top of housing
-
For above header mount, drill in back of housing
-
-
Drill hole in housing for electric
-
Mount housing using Tapcon screws: ¼" x 1 ¼" or ¼" x 1 ¾"
-
Reinstall screen roller
-
Set up remote
-
Install bottom bar
-
Install left and right track, and set tension on screen
-
Install cover
-
Set upper and lower limits
-
Spray left and right track with CRC spray silicone only (no oil or grease)